ESPLCD Button
| Info | |
|---|---|
| Download: | Sketchup STL |
| Print time | 07m 25s |
| Filament used | 0.09m |
| Filament cost | $0.01 |
| Quantity | 1 |
| Prototypes | 2 |
This little guy isn’t very special. It’s just a button that fits into the hole on the top of the ESPLCD Screen model. It didn’t take many prototypes to get right because it is so simple.
The first prototype didn’t work out very well because of the limited amount of space between the inside of the ESPLCD Screen and the actual button on the board. This necessitated creating a small “divot” on the inside bottom of the button as an offset. At the very small scale of the layer height (only .2mm) for these prints, I don’t know if that little divot even did much!
Wireframe: Edges: Autorotate: